LED Light Installation Instructions – DIY LED Installation

If you have been trying to install some LED lights in your home to no avail, these LED light installation instructions will help you in your quest.

When installed correctly, LED lights can help you cut on your energy costs, light instantly and allows you to customize the look of your house.

LED lights are as good as how you install them. So many tutorials are out there but you can trust this article to provide you with some reliable information.

What you will need to Install LEDs

Before beginning the project, you will need the following tools and materials:

• Pliers
• Electrician’s tape
• Screws
• Screwdriver
• LED lights to be installed
• Ladder
• Electric wires
• Any other tool that you might find necessary for your project.

Preparation to Install LEDs

The first thing to do is to decide where you want to install your LED lights. These locations can vary depending on your personal preferences. Many people like to install them under kitchen cabinets, in ceilings,and behind paintings.

Regardless of your choice, the location should be ideal for LED light installation.After picking your location, mark the spots where you want to install your LED lights. This is ideal for proper wiring.

Also, pick a spot where you will install the source of your LED lights. Most people prefer places that are away from the eyes of the occupants.

Finding the right LED lights for your home also falls under the preparation stage. You must be aware of the type of LED lights that you want to install in your home beforehand.

Wiring the LEDs

After marking your various spots, proceed to drill as many holes as you will probably need for wiring. Run the wires to connect the source of power to your LED lights.

All this time, make sure that the power connection from the main switch is off to avoid injuries. At the circuit box, you should find a way of connecting the LED lights’ cables.

When connecting the wires, it is important to adhere to the manufacturer’s instructions as they sometimes vary. However, the rule of the thumb here is,to begin with connecting the ground wires.

Then you can proceed to the black and white ones.

Install the LED Lights

Again here, you will have to rely majorly on the instructions of the manufacturer. Connect the wires to your LED lights accordingly then use a screwdriver to tighten them in place.

Remember to cover all the exposed wires with masking/ electrician’s tape to avoid short-circuiting.

Double check your connections because any slight mishap will cause your lights not to work. This also prevents you from wasting time once you are done.

Test your LED connection

After double checking and you are sure that you did every connection right, it is time to assess your work. Turn on the power from the main switch and then turn on your LED lights controller.

Observe how your LED lights come on. If you adhered to the previous steps discussed above, the lights should turn on instantly.

If the fuse blows or the light is inconsistent, it is an indication that something is wrong with your connection. Go back to the junction box and check whether there are some wires crossing one another or exposed.

LED Installation Pro Tips

• If a switch box does not exist, you can create one using your telephone jack’s existing electrical outlet or any other similar item.
• You can regulate the amount of light that your LED lights produce by installing a dimmer switch as well.
• Before installing your LED lights, first, make sure that they are in good condition by testing them first. If they are not lighting on the table, they cannot light when you install them on your ceiling.
• Always make sure that the power is switched off when working. This will prevent you from electric shocks and injuries that may delay your project.

Conclusion – LED Light Installation

For anyone looking for LED light installation instructions, this article provides you with just that. The entire process depends on how well you can follow the instructions provided by the manufacturer.

Additionally, you have to gather all the tools and materials that you will need for the project in advance.

Pick and test your LED lights before installing them to avoid disappointments and most importantly, observe safety measures. Always make sure that the power is switched off.