LED Glow Interior Lights Installation

LED Glow Interior Lights Installation in 2019

Whether it is for your home or vehicle, LED lights can not only be a good source of light but also amazing decorators. Most people struggle with LED glow interior lights installation.

Fortunately, this article takes you through the step by step procedure of how to go about the project.

Because there are many designs and procedures for installing these interior LED lights, we focus on how to install LED Glow lights in your car. This tutorial takes you through everything that you need to know.

How to Install LED Glow Interior Lights

1. Preparation

The preparation stage is very important as it sets the tone for your project. If you fail at this stage, chances are you will fail in the whole project. First, start by determining the area to which you want to install your LED glow interior lights.

You should then remove any old fixtures that may prevent you from working properly. It is also during the preparation stage that you will gather all the tools and materials that you will need for the job.

Some of the common tools include pliers, electrician’s tape, screws,and screwdrivers. You will also need to have the LED glow interior lights to be installed in place.

2. Mount the Control Box

After prepping the area of your car that you want to install your LED interior lights, the next step is to mount the control box to a place of your convenience.

For most people, the control box is mounted at a spot near the driver’s staring wheel. To mount the control box, remove the film from the double-sided tape and press the control box to your ideal location.

The control box should be able to stick in place depending on how strong the adhesive of your desired product is.

3. Run the LED Wires

With the control box firmly in place, the next step is the run the LED wires to all the spots that you will mount your LED lights.

When running the LED wires, ensure that none of them is visible or loose. Also, be careful not to cut/pinch the wires or harm them in a way that they cannot function properly.

4. Mount the Interior LED lighting Tubes

The next step is to mount the LED lighting tubes to your ideal location. Start with the ones located under the dashboard as you proceed to the ones that are further away.

When mounting the tubes, ensure that you tighten them in place using the zip wires provided by the manufacturer. It is also important to adhere to the manufacturer’s instructions just in case there are some alterations.

4. Connect the Wires

With every part already in place, it is time to connect the wires and complete the circuit. Start by connecting the red wire to the blue connector of the other red wire in the circuit.

In your fuse box, locate a 12V fuse and remove it. Snap the fuse that you have just removed into the other circuit. You should then snap the other circuit into the spot where you have just removed the fuse.

The next step is to ground the ground wire into any bare metal grounding wire location. Most LED glow lights have a feature that allows them to light when the vehicle’s doors open.

However, this is mostly an optional feature. If you choose to take this option, simply connect your ground wire to run through to your door’s bare metal ground location.

5. Test Your Connection

At the end of the project, the best way to figure out if you have been successful or otherwise is by testing the functionality of your LED interior lights.

If you are using a kit that has a sound activation mode, you can fine-tune the lights’ performance by adjusting the sensitivity nob. This will allow the lights to react sensitively to the music that you play in your vehicle.

Conclusion – LED Glow Interior Lights Installation

LED glow interior lights help your design and decorate your home or vehicle. However, most people still do not know how to go about this simple project.

Fortunately, this article has elaborated how to go about the project in the shortest time possible. Led glow interior lights installation does not have to be stressful.

All you have to do is gather all the tools and materials that you will need for the project and adhere to the manufacturer’s instructions.

Leave a Comment